Clearing namespace and memory

Question

Hi there,

I've run into some issues where some variables get stored in memory and get reused when running new snippets of code.

I'm looking for a way to reset everything: the whole namespace; clearing out all the data from GAUSS' memory.

The two ways I know how to do this are:

Since both of these methods are quite a hassle, I just wanted to check if there was another easier way doing this.

Thanks!

1 Answer

aptech · Answer 1

Yes, there is a MUCH easier way! The new command clears out all variables and procedure definitions in the GAUSS workspace.

 // It is a good idea to start your programs
// by clearing out your GAUSS workspace
// variables with the 'new' command
new;

1,773

aptech · Answer 2

Yes, there is a MUCH easier way! The new command clears out all variables and procedure definitions in the GAUSS workspace.

 // It is a good idea to start your programs
// by clearing out your GAUSS workspace
// variables with the 'new' command
new;

1,773

	// It is a good idea to start your programs
	// by clearing out your GAUSS workspace
	// variables with the 'new' command
	new;